Pneumatic winch motor and reducer are connected to both sides of the drum, which makes the winch small in size, light in weight, compact in structure, simple in operation, easy to maintain, and can achieve stepless speed regulation within a certain range. Realized, reliable braking. Manual operation is possible without compressed air.
Usage considerationsedit
1. Pneumatic motor first, then the transmission gear starts to run. Before starting, you should brake the brake band on the reel, and release the brake lever on the large gear, so that the reel does not rotate, only the large internal gear rotates.
2. If you want to start the reel, you must first completely release the brake band on the reel, and then tighten the brake band on the large internal gear. At this time, the reel is rotated and wound around the wire rope to work.
3. In the working process of the pneumatic winch, if you want to suspend the operation of the pneumatic winch, you can release the brake band of the large internal gear and then brake the brake band on the drum.
4. When starting an electric vehicle, the two brakes cannot be braked at the same time, otherwise the motor will be easily burned.
5. The temperature of the drum brake belt and bearing of the pneumatic winch should not exceed 70 ℃. If the temperature rises sharply, it must be stopped and inspected immediately.
Operation and maintenance editing
1. Do not arbitrarily remove the parts of the tool and operate it, in addition to affecting the safety of the author, and causing damage to the tool.
2. If the tool is slightly faulty or cannot reach the original function after use, it can no longer be used, and it should be checked immediately. Check and maintain the tool regularly (about once a week), add grease to rotating parts such as bearings, and add oil to the air motor.
3. When using various tools, be sure to follow various safety regulations and instructions for use.
4. Use appropriate tools to work. Too large a tool is likely to cause work injury. Too small a tool is likely to cause tool damage.
5. The inlet pressure at the inlet of the tool (non-air compressor outlet pressure) is generally 90PSIG (6.2Kg / cm ^ 2), too high or too low will damage the performance and life of the tool.
